Introduction
Shaft extensions are a simple and effective way to add length to your golf clubs without replacing the entire shaft. Whether you're a taller golfer or simply want more reach, this guide walks you through the installation process step by step.
What You'll Need
- A shaft extension (aluminium or graphite, matched to your shaft type)
- Two-part epoxy adhesive
- A vice with rubber clamp
- Sandpaper (120 grit)
- A cloth and acetone or isopropyl alcohol
- A ruler or measuring tape
Step-by-Step Guide
Step 1: Remove the Grip
Use a hook blade to cut away the existing grip and remove all old tape from the shaft butt end. Clean the area thoroughly with acetone.
Step 2: Prepare the Extension
Lightly sand the end of the shaft extension that will insert into the club shaft. This roughens the surface for a stronger epoxy bond. Wipe clean with a cloth.
Step 3: Mix the Epoxy
Mix your two-part epoxy according to the manufacturer's instructions. Work quickly as most epoxies have a short working time once mixed.
Step 4: Apply Epoxy and Insert
Apply epoxy to the sanded end of the extension and insert it firmly into the butt end of the shaft. Twist slightly to ensure even coverage. Wipe away any excess epoxy immediately.
Step 5: Allow to Cure
Leave the club upright in a vice or club holder for at least 24 hours. Avoid applying any stress to the joint until fully cured.
Step 6: Regrip
Once cured, regrip the club as normal. See our How To Regrip Golf Clubs guide for full instructions.
Important Notes
Extensions of up to 2 inches are generally acceptable for most clubs. Beyond that, you may need to adjust the swing weight. Always check the rules of golf if you're playing competitively, as there are length limits for clubs.